Indestructible "Toothpick"

By Terrorbirb on May 08, 2019

4  707  0

After frying multiple Crazybee F3 and F4 brushless whoop boards I decided to try and build something more durable. I had all the parts from previous "Toothpick" build attempts. I ordered the Iflight Succex 16x16 stack and made a remix of a canopy I found on Thingyverse to fit over it. I wanted something to protect everything inside in case of crashes. It's printed in 98a TPU. After removing a few unnecessary bolts and zip ties, the build is about 6 grams heavier than with a Crazybee board, but flies pretty much the same.

Photos

Discussion

Sign in to comment

Guides & Reviews

24 1,808  27
20 days ago

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
25 6,757  24
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more