Frame was hand crafted by my friend Georgios Petritis (Thank you!) the canopy is a tomoquad corsa pre-production prototype (but probably the final versoin is the same or better
Still need to tune it a little to eliminate jello at full throttle, but here's the maiden on 2S
BetaFPV F4 AIO 12A
BetaFPV 1103 8000KV
Runcam Nano V2
TBS Unify 32 nano
XF-Race antenna
Lumenier Micro AXII shorty
Hyperlight 65mm
Flight Controller |
F4 2-4S AIO Brushless Flight Controller 12A V2 (BLHeli_S)
(40 builds)
Betafpv.com
|
$39.99 |
Motors |
BetaFPV 1103 8000KV Brushless Motors (4PCS) for 75X 3S
(2 builds)
Team-blacksheep.com
|
$39.99 |
Propellers |
PyroDrone HYPERLITE 65mm Props with 1.5mm Hub (5 Sets)
Heli-nation.com
|
$5.99 |
FPV Camera |
RunCam Nano 2
(184 builds)
Shop.runcam.com
|
$19.99 |
FPV Transmitter |
TBS Unify Pro32 Nano 5G8 V1.1 VTx Video Transmitter
(400 builds)
Pyrodrone.com
|
$29.95 |
Antenna |
Lumenier Micro AXII Shorty U.FL 5.8GHz Antenna (RHCP)
(12 builds)
Oashobby.com
|
$17.99 |
Receiver |
Team BlackSheep TBS Crossfire XF-Race Antenna 915MHz - Heli-Nation
(2 builds)
Heli-nation.com
|
$5.95 |
Receiver |
TBS Crossfire Nano Rx - FPV LONG RANGE DRONE RECEIVER
(1499 builds)
Team-blacksheep.com
|
$24.95 |
Video Receiver |
ImmersionRC rapidFIRE w/ Analog PLUS Goggle Receiver Module
(178 builds)
Getfpv.com
|
$159.99 |
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
you really need to change how that xf rsce is mounted, it should be vertically out the top of the canopy. it is explicitly meantioned not to lie it ontop of carbon like that. xf's rssi should be 99, unless in extreme situations. i would recommend you use an exacto knife and cut a little slit down the fin ontop of your canopy and slide the xf antenna into it
i understand this is not how you mount it, but it has been working well enough for me.
also, it is hard to see on the photos but there is a layer of foam between the antenna and the frame. It is "function follows form" for this one :)
I did see the foam, but its still within 1cm of carbon. looks like you are almost failsafing every time you turn (And it is always on 50hz instead of 150hz when its under 98%, so you are loosing some butter). Just letting you know ;)
Other than that is is an awesome build!
ok didnt know about the 150/50Hz.
will put in a thicker foam!
Thank you
no problem, vertical out the top is still best or if you were to rotate it 90 degrees so its sticking out from under the carbon. If you are up for it just test it out in different positions and see what difference it makes ;)