Had plans to make a nice 7" long range cruiser with this but when I broke an arm on the Purple People Eater I decided to build this as a 5" racer instead.
Frame |
Hyperlite Floss 3.0 Race Frame 5"
(14 builds)
Pyrodrone.com
|
$44.99 |
Flight Controller |
RDQ JBF4 Bardwell F4 AIO 30x30 Flight Controller V2 w/OSD
(2 builds)
Rotorriot.com
|
$34.99 |
ESCs |
RDQ Bardwell 3-6S 32Bit 30A 30x30 4in1 ESC
(2 builds)
Rotorriot.com
|
$49.99 |
Motors |
4 x IFLIGHT XING X2208 2-6S FPV NEXTGEN MOTOR UNIBELL
(16 builds)
Pyrodrone.com
|
$91.96 |
Propellers |
Azure Power Johnny Freestyle 4838 Propeller (Set of 4)
(12 builds)
Getfpv.com
|
See Site |
FPV Camera |
RunCam Micro Sparrow 2 Pro
(7 builds)
Shop.runcam.com
|
$41.99 |
FPV Transmitter |
TBS Unify Pro 5G8 HV (SMA)
(596 builds)
Getfpv.com
|
See Site |
Antenna |
Lumenier AXII Stubby 5.8GHz Antenna (RHCP)
(232 builds)
Getfpv.com
|
$14.99 |
Receiver |
TBS Crossfire Nano Rx
(1501 builds)
Getfpv.com
|
See Site |
Batteries |
Pyrodrone Graphene 1600mAh 6S 22.2V 75C
(5 builds)
Pyrodrone.com
|
$31.99 |
Hardware |
2 x Tools for FPV
(57 builds)
Racedayquads.com
|
$13.90 |
Hardware |
4 x 2MM THREADED M3 ANODIZED STACK SPACER NUT (5 Pcs.)
(12 builds)
Pyrodrone.com
|
$7.96 |
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
Nice looking build, I really like that green. Would you happen to still have the link to that canopy? Also, the supports for the printed canopy look unusual, what software are you using?
Thanks! The canopy was designed by M490FPV (https://rotorbuilds.com/profile/9078/) and can be found here: https://www.thingiverse.com/thing:3729210
I did the sliding in Cura 4. Don't quite remember all the settings though. Hope that helps!