MRM225 w/RS2205S-2300kv & Zeus 30A

By AcroFPV on Jan 08, 2017

3  210  0

This is a build I did for a client. I really love using this frame because it has plenty of room for any component on the market, plus extra room on top to hold a larger 1550mah 4S lipo AND a HD Cam :)

Photos

Part List

Frame

MRM225 Carbon Fiber Mini 225mm Frame (5 builds)
Multirotormania.com
$48.00

Flight Controller

MRM Mantis F3 Flight Controller - MultiRotorMania.com (40 builds)
Multirotormania.com
$28.00

ESCs

4 x MRM Zeus S 30 Amp BLHELI_S ESC
Multirotormania.com
$68.00

Motors

4 x eMax RS2205S 2300KV Brushless Motor (2 builds)
Multirotormania.com
$80.00

Propellers

DAL CYCLONE Series T5045C High-end Propellers - Full Set
Multirotormania.com
$3.20

FPV Camera

Mini 600tvl Sony Super HAD CCD FPV Camera
Multirotormania.com
$38.00

FPV Transmitter

Foxeer TM200 200mW 5.8G 40CH Mini Race Band VTX – MultiRotorMania (12 builds)
Multirotormania.com
$18.99

Antenna

VAS 5.8GHz BLUEBEAM WHIP Antenna Set (2 builds)
Multirotormania.com
$33.80

Receiver

FrSky XSR - S.BUS RECEIVER – MultiRotorMania (50 builds)
Multirotormania.com
$25.99

Batteries

Tattu R-Line 1550mAh 95C 4S1P lipo battery pack with XT60 – MultiRotorMania (49 builds)
Multirotormania.com
$36.99

Power Distribution

MRM Micro PDB with 5v and 12v BEC – MultiRotorMania (13 builds)
Multirotormania.com
$2.00
Show stores (1)

Discussion

Sign in to comment

Guides & Reviews

28 1,471  11
22 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,962  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more