1s Frankenpick

By Tmistretta89 on Dec 08, 2019

13  325  0

Bought a toothpick that was a good deal and long story short i ran into problem after problem. Flight controller and vtx problems to finally breaking the frame. So i decided to glue the frame with Johnny Weld and build a 1s toothpick!! Especially since it already had those high kv hyperlites perfect for 1s! Plus i wanted to try out the JMT play FC since it was so cheap. 37.5 gram without battery and 45.3 grams with small 1s but will be getting larger 1s soon.
Maiden Footage below

Photos

Discussion

Sign in to comment

Guides & Reviews

58 4,635  47
30 days ago

For the longest time we've been limited to 3 to 4 minutes of flight and lots and lots of batteries. With more efficient motors and frame designs it's now possible to push the envelope much further. This guide will walk you through the process of building a micro long range quad capable of flying 8-30 minutes and more than 4km. The build is moderately difficult, but with the right tools and steady hands..

Read more
36 2,683  19
Jul 20, 2020

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more