Catalyst Machineworks Banggod 7" HD

By denbleyg on Jan 22, 2020

13  827  4

Catalyst Machineworks Banggod 7" HD. STL files provided by SasQUADtch on thingiverse. A few changes were made from those files to make the antennas work for me.

Photos

Discussion

Sign in to comment

victorsmonster   Jul 15, 2020  

I made the mistake of running this exact prop/motor combo with individual 55A ESCs and they're not powerful enough. Have you recorded the amps you're pulling? Thanks!

kwadkenstine   Jul 16, 2020 

If i may answer , the 55a esc is plenty . its usually the lipo that cant push the amps

bugsysiegals   Jun 15, 2020  

How'd you wire up the Air Unit since BrainFPV doesn't output enough voltage?

triumphantduke   Apr 15, 2020  
1

Hi,

Could you post a review of your build? performance, flight times, range, etc? would you do anything different?

Guides & Reviews

29 1,579  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
45 5,038  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more