First build. Mostly based upon Nurk's cinematic freestyle build.

Build Notes

• I'm not overly happy with the quality of my solder joins. I believe it was partially a problem with my iron tip not transferring heat efficiently. I ended up with shiny joins, but I struggled. Next time I'll get a better iron and improve my work.
• I realized I have no idea how to add an XT60 connector correctly. I ended up accidentally melting the connector that came with the ESC. Fortunately I had some extra pre-built pigtails. So I desoldered the original from the ESC and added a new one.
• I accidentally cut some of the motor wires too short. This mistake made mounting the ESC on the standoffs difficult as the motor wires were too tight.
• Re-pinning the FC->ESC connector was the brightest idea I had. So much simpler.
• I rotated the ESC 180 degrees because the capacitor/pigtail would not fit with the DJI Air Unit in the back.
• Brief scare as I accidentally splattered some solder on a few pads on the ESC. Some solder wick took care of it, no shorts!

Flying

• I performed a hover maiden flight. I'll need a lot more sim time before trying FPV again. But I can't wait to get this thing up in the air again!
• This thing is sturdy. I had a few hard crashes (and I might have gotten stuck in a tree) but the worst so far has been a bent prop.