pt0x 3.0

By pt0x on May 24, 2020

9  290  2

After my 2.4 build This is version 3.0. A new Armattan Marmotte DJI Edition, so I have a second good 6s quad.

This time most of the parts are the same. just general improvements due to experience. Electronics are all the same, just got rid of the Ethix v3's because they are super weak. Or at least my batch of 8 motors are. I keep using them on my 2.4 quad untill they are behond repair. 3.0 is rocking Cyber Xings 2306 1777kV.

This quad will run the GoPro 8 and the old marmotte a session

TBS Nano RX is underneath the Caddx Vista. this time cleaner and easier to reach.

Photos

Discussion

Sign in to comment

floxflux   9 days ago  
1

how does the twing f7 mini stack holding up? how much auw?

pt0x   9 days ago 

hi! I actually just replaced it. the icm gyros are a pain to (fine)tune. so im now using the goku f722 mini stack (so with the esc) my auw is 735g with the gp8 etc.

Guides & Reviews

39 4,137  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
28 7,901  38
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more