Frame |
TWIG ET5 Extraterrestrial 5 Inch FrameLime Green
(4 builds)
Airbladeuav.com
|
$37.99 |
Flight Controller |
Diatone Mamba MK3 Mini Tower 35A 3-6S
(2 builds)
Airbladeuav.com
|
$59.99 |
Motors |
4 x AirBlade Superman 1606 Ultralight 4/5 inch Brushless Motors
(5 builds)
Airbladeuav.com
|
$63.96 |
FPV Transmitter |
Team BlackSheep TBS Unify Pro32 Nano V1.1 5G8 Video Transmitter
(400 builds)
Airbladeuav.com
|
$29.99 |
These look great! Any reason why Blue is running bi-blades? Do the motors still not have enough torque for tris on 6s?
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
Hey nice racers there ! I think the hobby will take this direction lighter being more durable and with time the performance will match 300g typical 5 inch racer.
What do you mean you have the worst of luck with Jhemcu 30 amps AIO ? do you recommand them ? what issues did you experience ?
It wasnt specifically meant about the Jhemcu Board but instead, all AIO boards in general. They just don't last for me. Something always breaks. Ive destroyed at least 3 Betafpv, 2 Nameless, 1 Diatone, 1 Flywoo and 1 Jhemcu. I actually like the Jhemcu's. Cheap like chips. But look great and easy to solder with a decent layout.
thanks for the reply. did you use 2 ESC pads per motor wire or one was enough...
I see what you mean, get 2 AIO from JHEMCU is better then one from betafpv... AIO just fry a lot in general
you have to connect all three motor wires. each pad has three for a reason, the motor will not spin properly otherwise. look at the aikon esc up in the pictures for an example
yes I know but fr this specific ESC each wire can use 2 pads = 6 pads per motor... let me try to upload a pic to make myself clear
I am trying to figure out if you get enough amps with the outside pads which are easy to solder or if you went the hard way and bridged for more current throughput
they are all the same pads. you dont need to attach it to both sets. the design allows you to stagger your wires. For example use two outer pads in the front and use 1 pad on the flip side in the middle. Picture of the back of one of my betafpv installs, since these pads are stupidly close I use the middle back pad, then flip it over solder the two outer pads on the front