CineQueen

By DroneDome on Jun 21, 2020

4  139  0

Built my version of a CineQueen. All parts were from GEPRC except the Caddx Vista, receiver, and the props.

  • Link to how I wired my first build (and second build): View the PPT Build Diagram
    Note: My first attempt to wire up the quad had a couple of issues with the OSD not showing, and the LED lights malfunctioning. I believe it was due to the Capacitor placement so I used wires to relocated it in a reasonable place. The link shared is the final wiring end result; included is a Runcam I used for my second build. The quad is not balanced well, until I use the lipo battery and place it near the front. Unbalanced quad towards the back can cause issues with rear motors overheating.

Photos

Discussion

Sign in to comment

Guides & Reviews

29 1,491  11
23 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,980  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more