BandoRacers Basher rehashed

By daich on Jul 02, 2020

11  237  2

Rebuilt the RotoriousFPV BandoRacer 4" Basher with some decent hardware
good riddance to those nasty Eachine Tyro 1607 motors and noisy Racerstar AIO FC
Hoping to get rid of a wierd judder when coming off the throttle. This was happening with both the 1407 and 1607 motors.

These motors feel extremely well put together. They spooled up super quiet and silky on the bench. Btw the bearing size for this motor is 7x3x3
Prop choice is a bit limiting as all the t-mount 4" props are low pitched -- Gemfan's 4023 tri and 4025 biblade and HQprop's 4x2 tri and 4x2.5 bi

This will be my first F7 flight controller. All set up, the CPU usage sits under 5% on the bench.

Overall change was a loss of 4 grams, not a bad weight. Definitely not an ultralight 4" racer. This will be a perfect freestyler.



Sign in to comment

Whiffles   Jul 03, 2020  

Moving up to 4" eh? And here I am moving down to 3" and smaller.

daich   Jul 05, 2020 

yeah i built a few 4" a year or so ago but there werent many prop choices. now we got four more to add to the mix and Im excited to see how they are

Guides & Reviews

29 1,573  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,035  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more