Schmetterbiene 75

By Bockol on Jul 01, 2020

8  292  2

Discussion

Sign in to comment

Sharkey5150fpv   Jul 06, 2020  

Hello, NOICE build! I like the little extra strip of protective red foam on the top. I'm willing to bet it will help protect the fragile betafpv canopy while also giving the model a little more angle when crashed up-side down so that you can use turtle mode with less chance of burning out an ESC or motor. I also must admit, it also gives it a cool "punk rock vibe" looking like a red Mohawk. Only question; What's your approximate flight time per 3s 300mah pack? Thanks!πŸ‘πŸ‘πŸ‘πŸ‘πŸ¦ˆ

Bockol   Jul 07, 2020 

Hi, thank you. i get around 3- 3.5 min of flightime outdoors. The new canopy are very durable, much better than older ones... I like the red punk haircut :-)

Guides & Reviews

29 1,572  11
26 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 5,035  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more