HYPERLITE UL3 FRAME W/ JHEMCU GHF411AIO 30A

By Boeseefus on Jul 13, 2020

5  195  2

Discussion

Sign in to comment

HyDrone_FPV   Jul 21, 2020  

Nice build! I have a set of those motors on a 2in I just built and so far I really like them. What length screws are you using to hold the props on? The ones I have dont really work that well. As soon as I throttled up to take off for my very first flight 3 of the 4 of my Hulkies exploded so I assume I tightened them too much and cracked the hub, and then later I lost a prop because they were not tight enough.

Boeseefus   Aug 17, 2020 

im using normal m2 screws. long enough to have a little bite , but not so long that it gets to close to the windings. those motors are pretty large for 2inch. It could just be those 2 inch props cant withstand the torque. Really not sure on that.

Guides & Reviews

58 4,661  47
30 days ago

For the longest time we've been limited to 3 to 4 minutes of flight and lots and lots of batteries. With more efficient motors and frame designs it's now possible to push the envelope much further. This guide will walk you through the process of building a micro long range quad capable of flying 8-30 minutes and more than 4km. The build is moderately difficult, but with the right tools and steady hands..

Read more
36 2,686  19
Jul 20, 2020

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more