Source One Mid-Long
I want to rebuild my Source One build. I'll use a new Matek F722SE and new AMAX 2207 motors and Prodrone antenna.
http://prodrone.pl/index.php/en/about-us/
Solder the ESC:
I want to use the ESC current sensor and the ESC voltage output, though the FC has own current sensor.
Solder Points:
GPS - 4V5, GND, RX1, TX1 (powered in USB mode)
RX - TX2, 4V5, GND (powered in USB mode)
Bluetooth: 3.3V, GND, RX6, Tx6 (powered in USB mode)
Active Buzzer: G, 5V Bz-
ESC current: FC Curr Pin
VTX smart audio: TX3
Camera Controll: RX4 (RX4 has 200ohm built-in, can be remapped to PWM camera controll)
Add a Low ESR 35V 1000uF to main power.
Solder Result:
Conductivity check (fine):
Check every BEC, and the main power.
Final form:
I use TBS ND filters with these very good 3d parts. (Thanks to Loynik)
https://www.thingiverse.com/loynik/designs
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
New Message for NyanCatFPV