I have been messing around with getting a setup that I am really happy with for medium to long range flights. I originaly built a 8" iFlight that I almost lost in a lake when the flight controller freaked out. I got a 7" Glide frame to replace it and I was never quite satisfied with it and the arms were not able to use 19mm motor mounts that the Brotherhobby 2810 motors that I wanted to use so I decied to try the Pyrodrone Source One 7" frame.

First off I am very happy with the frame. The carbon is great quality and the frame overall is very well thought out. I did decide to "slam" this build and went with 20mm standoffs instead of 30mm that the frame came with. I often use two packs in parallel with one on the top plate and one on the bottom so I wanted to keep the weight as close to center as possible.

On this build I am using the Geprc Span F722 dual gyro FC and 50 amp esc, a TBS M8 gps and Frsky R9mm receiver. I also selected the TBS Unify Pro 32 HV VTX and paired that with the new RunCam Phoenix 2 Bardwell edtion camera and a Luminier Axii 2 Long Range antenna. And of course the beautiful Brotherhobby 2810 1180kv motors with the red and blue anodizing on the bell. Then to finish off the build a Ummagrip battery pad and 3d printed parts from Brain3d and kwad skids from Kwad3d.

Thanks for checking out my build!
Happy Flying!