Everycopter Y6 (full carbon)

By cjdavies on Dec 18, 2020

4  62  0

My third Y6 build using my Everycopter hub plates, this time using roll-wrapped carbon fibre rods instead of hardwood dowels. I bought the rods direct from the manufacuter in China & used a circular mitre saw with a continous edge diamond blade to cut them.

Motors/ESCs came from one of my previous Y6 builds, while the Pixhawk Cube Orange flight controller & Here2 GPS came from my Hexsoon EDU450 quad build.

It certainly looks a lot slicker than its wooden predecessors!

Photos

Discussion

Sign in to comment

Guides & Reviews

32 5,132  51
Nov 19, 2020

FPV has had quite a journey. Just a few years ago we started racing drones around a track and doing flips over trees, but professional cinematic FPV is a more recent development. DJI has always owned the drone photography market, but smaller acrobatic drones are starting to enter the market. They have the advantage of close proximity flight indoors and around people. There's more artistic freedom and..

Read more
Aug 26, 2020

For the longest time we've been limited to 3 to 4 minutes of flight and lots and lots of batteries. With more efficient motors and frame designs it's now possible to push the envelope much further. This guide will walk you through the process of building a micro long range quad capable of flying 8-30 minutes and more than 4km. The build is moderately difficult, but with the right tools and steady hands..

Read more