My dream build. The only 3D Printer parts I created are the Vista & Immortal T antenna mounts. If you mount the Vista mount horizontally on the printer bed, you should not need supports (TPU supports are so hard to remove). The Immortal T mount should be placed vertically with the closed end on the bed. You'll need to trim the Vista's antenna cable shroud a bit & bend it a little before installing it in the mount. Use a file to take the edge off the top plate where it provides restraint for the XT60 connector. Let me know what you think
Thingieverse Link: https://www.thingiverse.com/thing:4750503
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
New Message for Stevensbox