Exorcist frame with a vista and toa motors.. This build took longer than I expected, the key was 5mm spacers.
Photos
Part List
Flight Controller |
30.5mm MATEK F405 SE MPU6000 OSD Baro Blackbox 2 8S AIO F4 Flight Controller for FPV Air Unit FPV Racing Freestyle Drones
(2 builds)
Aliexpress.com
|
$38.99 |
ESCs |
4 x Spedix LS40 Slim 40A 32Bit F4 ESC
(3 builds)
Pyrodrone.com
|
$75.80 |
Propellers |
HQ Prop ETHIX S5 5x4x3 Tri-Blade 5" Prop 4 Pack - Light Grey
(80 builds)
Racedayquads.com
|
$3.49 |
FPV Camera |
Caddx Vista Digital HD System for DJI HD FPV
(98 builds)
Pyrodrone.com
|
$164.99 |
Antenna |
VAS Minion PRO 5.8GHz U.FL Antenna - Choose Your Polarization
(3 builds)
Racedayquads.com
|
$19.99 |
Receiver |
TBS Crossfire Nano Rx FPV Long Range Drone Receiver
(1506 builds)
Pyrodrone.com
|
$29.95 |
You really had to go the extra mile to get that vista in there. I'm impressed you got it all in. The way you mounted the esc's took me a while to figure out, very creative. Very clean, considering all the wires you had to route. The prints you made for your wiring/esc mounting are fascinating! I see that they hold the esc's, and they keep the wires safe from prop strikes, and generally lend some order to a lot of wires, in a small space. How are they attached? Are they ALSO the 5mm spacers??
Thanks for your comment, the wiring did take some effort to work. The print has a aluminum 5mm spacer (no thread) pressed into it. so the spacing amount is even all around. I will try and post some better pictures later.