my building shenanigans have constantly been displaced onto the back burner these days (as well as flying!)

should have studied the arms more, looks like the flight controller bolts are part of the structure that secures the arms...ugh.
still, a very light frame for what it is. I'll be hard pressed to keep it under 250g but it will still be a very lightweight build.

the frame uses M2.5 bolts and standoffs. kind of unvconventional although I hear the micro apex does the same.

Thinking after the fact, probably going to a micro apex with 5" arms would have been a better option with similar outcome. The amax kit is very complete and nice but the apex is a better design overall, and a little more costlier. The main reason for going to the F5mini frame was because it can take a whoops sized (25.5x25.5) AIO board which is not very common in this format yet (fpvcycle frames like to do that too but they are not very accessible here in Europe)
But in the end I ended up using a 20x20 stack...oh well.

flight stack is from a 6s geprc cinego which I had in a 4" 6s gecko previously

I'm listing out the stack details below as it was not easy to find.
Electronic System(STABLE PRO F4 35A):
STABLE V2 F4 Flight Controller Specs：

Model:STABLE F4 35A
MCU: F405
IMU: MPU6000 gyro/accelerometer (SPI)
OSD: BetaFlight OSD w/ AT7456E chip
Baro:NO
BEC Output: 5V@3A
Integrated LC Filter
Firmware target: OmnibusF4SD
Size: 26x26mm board, 20mm mounting holes (M2)
STABLE V2 F4 ESC BL32 2-6S 4in1 Specs：

MCU:STM32F051
Input:2-6s lipo
Constant:35Amps
Burst:45Amps
Dimensions:3131mm(including the power pads)
Mounting Holes:2020mm,M2
Supports Dshot1200,Proshot,Oneshot,Multishot
Current meter: Yes
Target: GEPRC-BL32-4IN1

Playlist of all flights on this frame

9th October 2022
maiden flight 650mah 6s

29 May 2024
finally got to fly this proper. flies very well
365g AUW