Noisy Cricket 5"

By tylargh on Mar 06, 2017

6  291  0

Racer. Catalyst Superlight 5". Designed to use BF 3.1+, and utilize all features of BF OSD. Uses the barebones Omnibus F3, which is cheaper and allows to take advantage of a more full featured PDB. Current and Voltage come from the PDB, RSSI via XM+.

Photos

Part List

Frame

Speed Addict SuperLight (5 inch)
Catalystmachineworks.com
$85.00

Flight Controller

Airbot Multicopter
Shop.myairbot.com
$34.99

ESCs

4 x Airbot Multicopter (3 builds)
Shop.myairbot.com
$139.96

Motors

2 x T-motor F60 2207-2450kv (Set of 2 motors)
Catalystmachineworks.com
$79.98

Propellers

HQ 5x4.5x3 V3 PC Light Blue
Pirofliprc.com
$2.99

FPV Camera

Foxeer Monster 16:9 1200TVL FPV Camera 2.5 Lens
Pirofliprc.com
$42.99

FPV Transmitter

TBS UNIFY PRO 5G8 HV - RACE (SMA) 25mW - 200mW (544 builds)
Catalystmachineworks.com
$24.95

Antenna

Team Black Sheep Triumph FPV Antenna (SMA) (4 builds)
Catalystmachineworks.com
$39.95

Receiver

XM PLUS (Mini SBUS Non-telemetry Full Range) (1423 builds)
Pirofliprc.com
$12.99

Batteries

Tattu 1300mAh 75C 4S1P lipo battery pack (103 builds)
Pirofliprc.com
$28.99

Power Distribution

PDB-XPW W/ CURRENT SENSOR 140A & DUAL BEC (2 builds)
Pirofliprc.com
$11.99

Misc Parts

U.FL to SMA Female Right Angle Pigtail (4 builds)
Catalystmachineworks.com
$6.50

Misc Parts

FPV Racing LED SET (4 INCLUDED) (5 builds)
Catalystmachineworks.com
$4.99
Show stores (3)

Discussion

Sign in to comment

Guides & Reviews

28 1,416  11
21 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,911  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more