Spawntooth 3in Frame by Jack3D and FourLoveFPV

••
••

This frame comes cut at 1.5mm thickness standard - Tested for robustness considering its class
custom thickness can but cut upon request by Jack just send them a PM on social media platforms
(3 frames minimum per custom thickness order)

••
••

• 16x16 // 20x20 // 25.5x25.5 AIO / Stack mounting options for versatility (Digital or Analog friendly)
• 1.5mm thickness = 5g~ frame
• 2mm thickness = 5.6g~ frame
• Side notch for locking rubber-band in
• Motor holes positioned for motor wire routing

••
••

In the end my build totaled to around 38-39g without lipo and under 50g with a 500mAh XT30 or PH2.0 lipo!!

••
••

Would love to see Spawntooth carrying any Action Camera and after market prints for 18650 builds or whatever you think might add some extra spice

••

Thank you for looking ,

FourLove FPV