EVO 10" frame from Travis Brann. I kept this build "simple" but effective with the way the lines flow. I also slammed it from 30mm standoffs to 20mm as the Iflight Beast H7 AIO leaves a lot of room. Over the years I also have been striving to eliminate some, if not all zipties from my builds just to keep things super clean. Because the EVO arms can be positioned in different ways, I opted for hybrid. You can also do X and deadcat. The 3D prints are mostly from the TBS source one frame as you can use them on both the EVO and StaticX designs from Travis. The arm motor wire protectors are just 3D printed PLA tubes that I got off of thingyverse and extended to the arms width and length. The battery strap is from RJX hobby that I had made custom a long time ago, it just happens to fit this build. The straps are 1.5" wide. Running the quad on 6s with no issues. May eventually move to 8s and use the speedybee FC with the reaper 65amp ESC.