The frame is a Diatone GTR90. I thought it was a dope frame. While ataring at amazement of its size, i am determined to build it and fly adequately on 1s.

The problem now is that i need to find motors to match! 1s but with 4 hole mounting!

So I literally bought a Mobula6, and took that setup, printed an adapter for the 25x25 whoop board, and slapped it together! Just didnt realize the motor issue until i had finished EVERYTHING but that!臘路 Its running FRSky D8 on the SPI rx, and were even sticking with the onboard vtx, which claims to output 400mW!

Any suggestions!?

maybe ill just dremel the mounts so i can adjust the motors to fit!?

So thats the final outcome. I started by drling the center motor holes bigger by about a millimeter. That wasnt quite enough and was causing the motor clips to pinch and rub when screwed down. I ended up using some needle files to finely form the holes for the motors. I was also only able to utilize 2 motor screws so i reinforced them with ScrewGlue!

All in all im suprisingly happy with this build! My guess is that it woukd probably benefit to swap to a bigger torquier motor, and even jump to at least 2s, but im happy to say i built this on 1s as a Mobula6 conversion!