I have assembled the Cinerat for filmmaking, and it proves to be an incredibly versatile frame, particularly when equipped with prop guards, enabling both indoor and outdoor flight. The build is exceptionally sturdy and robust, capable of withstanding rough handling.

However, I am experiencing a relatively short flight time of about 2-3 minutes with a 6s, 1150mAh battery and GoPro 11 Mini. I suspect that the PID tune may not be optimized for my setup. I would greatly appreciate it if you could share your PID tune with me; any guidance on enhancing flight performance would be invaluable. Thank you in advance.

For those interested in the 3D aspect, you can find related files here. It's important to note that the FPV camera mount, specifically the holes for attaching the FPV camera on the front piece, is positioned too low in these 3D prints. This resulted in an inability to adjust the FPV camera angle properly.

To address this issue, I had to use longer standoffs for the top plate to achieve a higher position, modify some of the TPU, and incorporate spacers to allow for proper adjustment of the camera angle. Based on my experience, I would not recommend the front piece 3D print at all. Ultimately, I opted for the regular that Ethix provides.