This build is made on a base of a cheap 25$ eachine x220hv frame.

I chose this frame because it is a very thin frame, which is very aesthetic and allows for a touch of originality.

The assembly requires quite a bit of engineering because there is very little space to stack the different components.
I placed the CROSSFIRE nano RX module between the VTX WalkSnails and the bottom plate, therefore, there is access to the Bind button of the Nano RX from below the plate.

For the back, i designed a small TPU part to accommodate the double antenna, as well as the crossfire module.

As for the capacitor, there was little room at the front to be able to put it between the stack and the camera, so I positioned it flush with the XR60. that does the trick. This is the capacitor supplied with the xRotor F7 stack (680uf), to see if I would change it for one of 1000 uF.

I keeped the original straps found with the frame. they looked cheep but evething is ok for Flatgrass Freestyle :)

Hope you will enjoy my Ultra Barbie Drone !

Frame : X220HV
Stack : Hobbywing Xrotor F7 65A
Motors : Rcinpower Wasp Major 2020kv
VTX : Walksnails HD KIT PRO Dual Anthenna.
Camera FPV : Caddx HD PRO
Anthenna VTX : Walknsails de base
Recever : Crossfire Micro - Immortal T V2
Props : Gemfan Sbang 4934
Capacitor : Low ESR 680uf 35volt (gived with xrotor stack)