I was hooked at the video of Quadmovr his hexamovr5r1 build. So i search if i could find it, and YES, i found it at Armattan site.
Since it was my first hexa build, i asked quadmovr for some tips... His first tip was : Be gentle with the motors... as it was hard to find nice motors here in the netherlands, which i find suitable.. i ended up with these Xnova Freestyle hardline 2207-1650KV motors.... which of course were a little too much.

So i had to print ( PETg+carbon fiber) aditional arms, to make the frame more stif... and now it really rips .. :)

You find some foto's of the build, and some screenshots of the build from the 3D model. ( I moddeled it in 3D first ).
ALso you find the remaping of the motor-loyout with FETTEC configurator.

I used FETTEC setup, and TBS NANO VTX and crossfire. I soldered these both directly onto the FETTEC FC.
I allso used FETTEC OSD and Spike board.

For the lights i used CLRacing boards

It was hard to get the flight controller, so i used an old betaflight FC for remapping via Betaflight pass through... I had to use a resistor on the flight controller before it worked but it did eventually. So i could start allready.

• Note. The Mah and A in OSD are not right. FETTEC cant handle 6 ESC's at that point. I asked FETTEC help, but they could not help me.
  Hope you like this build.

• Best flight without the extra printed arm connectors.
  

• Flight with arm modifications.