Crabbage Patch Kid

By WishBeatsFPV on May 10, 2017

8  235  0

With my style of flying, I broke three bottom plates on the Rasvelg frame and pods. I saw LAZD flying his prototype at the palace of fine arts, and I just had to give this one a shot! I plan to try it with 4" props soon and perhaps swap out the tiny TBS linear antenna for a Triumph. Only took a few hrs to extend the motor wires, solder in a new FPV camera and button her back up. Can't wait for a maiden flight tomorrow!


Part List


Garagecrab (14 builds)

Flight Controller

OMNIBUS AIO F3 Flight Control with OSD (59 builds)




4 x BrotherHobby T1 1407 3600kv Brushless Motor (195 builds)


HQProp 3030x4 Props (2 builds)

FPV Camera

RunCam Owl 2 Nighttime FPV Camera

FPV Transmitter

TBS Unify Pro 5.8 GHz HV RACE Video Transmitter (544 builds)


FrSky XSR CPPM/S.Bus Receiver (35 builds)
Show stores (3)


Sign in to comment

Guides & Reviews

39 3,807  46
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
28 7,663  38
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more