This was a second build for a friend so Shrike 220 v2....V2. After messing with some of the different OSD options between cameras and PDB's, we decided to go with the new FCHUB-6S and Monster for a more simple setup. We stuck with 24a/kiss setup to maintain audible telemetry alerts. The cap runs under the FC and above the PDB to the FPV/camera side vcc/gnd and sticks out the back. Pretty simple setup just going for clean.
Photos
Part List
Show stores (7)Guides & Reviews
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read more
With the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
HI NICE BUILD CAN YOU TELL ME THE WHAT A CAP YOU THAKE AND HOW TOO SOLDER IT?
I think you are asking what cap and where to solder it....
I have since started soldering good silicon wires to it and attaching directly to battery pads. be sure to add heat shrink to each wire and heat near the cap.
Im adding a pic of the cap.
Ok thanks for helps me !
I think i solder a 330uf 35v cap on all 4 esc. But your Solution its better!