3D Printed Brushless Micro

By Macaca on Oct 04, 2017

3  160  0

This is the third version of our design, four slots are added in the arms to hide motor wires. Also trimmed the camera mount to prevent TX03 camera from moving around during flight. AUW is 51g with 1s 600mah battery.

BUILD INSTRUCTIONS

https://fpv99.wordpress.com/2017/09/13/fpv-micro-v3-build-instructions/

VIDEO

Photos

Discussion

Sign in to comment

Guides & Reviews

22 1,078  11
14 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
42 4,739  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more