I pre-ordered this thing as soon as it was available- There are no other frames like Neato on the market.
This was a lot easier to build than I anticipated. The pocket at the bottom really gives you more than enough room for your stack. It flies like a champ. I love the lines and attention to detail- this thing is damn clean.
Between this and my Tokio SX (https://rotorbuilds.com/build/5550).... I'm not sure which one I like more:)
Photos
Part List
Frame |
Fastback 5mm
(5 builds)
Neatoframes.com
|
$99.00 |
Flight Controller |
Holybro Kakute F4 AIO
(42 builds)
Getfpv.com
|
$40.99 |
ESCs |
DYS F30A 4-in-1 ESC BLHeli_S Dshot
(74 builds)
Getfpv.com
|
$44.99 |
Motors |
4 x EFAW 2407R 2800kv Motor
(5 builds)
Getfpv.com
|
$107.96 |
Propellers |
RaceKraft 5051 Tri-Blade (Set of 4 - Clear Red)
(123 builds)
Getfpv.com
|
$3.99 |
FPV Camera |
Foxeer Arrow Micro HS1202 FPV Camera V2 - Black
(76 builds)
Getfpv.com
|
$19.99 |
FPV Transmitter |
TBS Unify Pro 5G8 HV (SMA)
(596 builds)
Getfpv.com
|
See Site |
Antenna |
Lumenier AXII U.FL 5.8GHz Antenna (RHCP)
(148 builds)
Getfpv.com
|
$14.99 |
Receiver |
FrSky XM+ SBUS Mini Receiver
(1158 builds)
Getfpv.com
|
See Site |
How much space did you have above your stack? This frame is sick and id like to use a runcam split in it if i can.
Sorry to take so long to respond- I don't have a measurement but there's quite a bit of space above the stack vertically, it's side to side you'll contend with - the top nuts on my stack rub the sides.
If you're just stacking a vtx or receiver or something you can vhb tape to the top of your stack you'll be fine- if you're trying to add another stack layer you'll be really tight.
I'd love to see your set up if you end up going ahead with the build!
How has this frame been holding up? Any broken arms or anything yet?