MRM225 - Cicada30A + DYS 2550kv

By AcroFPV on Jul 14, 2016

3  180  0

This build was to test some new parts sent to me from a few vendors. BuddyRC sent me a set of 2205-2550kv motors to test. Sunrise sent me a set of their 30A Cicada BLHeli_S ESC's to test. And APC sent me some of their new 5x4x3 Props to test. The MRM225 frame was the perfect choice as it will take a lot of abuse, and also provides a Yi mount so I can get the HD video I need.

The OSO 35mm Mini PDB made it simple to install a Micro MinimOSD, along with both 5V & 12V pololus in a very compact layout.
Pictured with a Tattu 1550mah 75C 4S Lipo.

Photos

Part List

Frame

MRM225 Carbon Fiber Mini 225mm Frame (7 builds)
Multirotormania.com
$48.00

Flight Controller

MRM Mantis F3 Flight Controller - MultiRotorMania.com (40 builds)
Multirotormania.com
$28.00

ESCs

4 x Sunrise Cicada Blheli S/Dshot 30a (2 4s) Bb2 - www.readymaderc.com (11 builds)
Readymaderc.com
$63.96

Motors

4 x Edge Racing 2205 2480KV FPV Motor Lite Version (3 builds)
Buddyrc.com
$91.80

FPV Camera

Mini 600tvl Sony Super HAD CCD FPV Camera
Multirotormania.com
$38.00

FPV Transmitter

Foxeer TM200 200mW 5.8G 40CH Mini Race Band VTX
Multirotormania.com
$27.00

Power Distribution

OSO Mini 35mm PDB for the MICRO OSD
Multirotormania.com
$3.50

Misc Parts

5V 500mA Step-Down Voltage Regulator Pololu D24V6F5 (2 builds)
Multirotormania.com
$6.00

Misc Parts

Xioami Yi TPU Mount - MRM225
Multirotormania.com
$6.00

Misc Parts

12V Step-Down Voltage Regulator Pololu D24V5F12 (3 builds)
Multirotormania.com
$5.00
Show stores (3)

Discussion

Sign in to comment

Guides & Reviews

28 1,471  11
22 days ago

Until recently GoPros were delegated to larger quads. A typical GoPro weighs around 125g and we've only recently begun to mount them on 3" cinewhoops. Even that is a stress on the motors. Now we've got the "GoPro Lite". Remove the battery, displays and casing and you're left with a small, lightweight board and sensor. Wrap it in protective TPU casing and you've got a 30g micro GoPro. The Hero6 is..

Read more
44 4,962  47
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more