By Hypurr on Dec 10, 2017

8  646  2

Update: After a few flights and some experimentation, I've changed to Gemfan 2540 3 blade props. They make this little build rock and fit the frame much better. Only added 2g to the total weight but the thrust and pull increase more than makes up for it.

Just finished and so far no problems. It was easy to build and just fell in place, except for the buzzer. What to do with the buzzer...? Running Betaflight 3.2.2, DSHOT 600 and IBUS. Too bad this camera has no video in/out since the FC has an OSD but I'm unable to use it. Might have to remedy that in the future.


Part List


Eyas 112mm Carbon Fiber Quadcopter Frame Kit for Micro Racing Quadcopter Micro FPV Drone Support 1103 1104 1106 1306 Brushless M (4 builds)

Flight Controller

Flycolor RAPTOR S-Tower 12A BLHeli-S 2-3S ESC with F3 Flight Controller Built-in OSD


4 x Dragonfly MC1105 Micro Class Racing Motor 7500kv


Crystal Blue Gemfan Flash 2540 2.5 (145 builds)


GemFan 2035BN 4-Blade Propellers Purple / CCW + CW

FPV Camera

AKK BA3 5.8G 40CH VTX 0/25mW/50mW/200mW Switchable 600TVL 1/3 Cmos Micro AIO FPV Camera for FPV Drone Like Tiny Whoop Blade Indu (2 builds)


Flysky FS-RX2A Micro Receiver (3 builds)


Tattu 11.1V 3S 450mAh 75C LiPo Battery Pack with XT30 Plug for Multirotor FPV 90 to 150 Size


FrSky Taranis Q X7S Radio w/ Upgraded M7 Hall Sensor Gimbals (Carbon Fiber) (20 builds)


Fat Shark Dominator HD3 Core FPV Goggles (69 builds)

HD Camera

GoPro HERO5 Session (196 builds)

Misc Parts

Matek Systems 90dB 5V Loud Buzzer Lost Model Beeper Built-in MCU for CC3D Naze32 F3 F4 Flight Controller and PPM Receiver (3 builds)

Video Receiver

Furious True-D Diversity Receiver Module 5.8GHz System V3 Firmware 3.9 (22 builds)

Radio Module

FrSky R9M Transmitter Module (69 builds)


FrSKY 900MHz Super 8 Antenna for R9M and R9M Lite Module - FCC Version
Show stores (6)


Sign in to comment

Guides & Reviews

39 3,933  46
May 05, 2020

This guide will walk you through the process of building your first FPV quad. The goal with this design was to build a low-cost, lightweight quad, yet powerful enough to safely carry a GoPro in close proximity areas. I chose these parts to minimize the amount of soldering at no cost to the quality. A typical build requires around 30 solders while this only needs 25. It's not a huge difference, but..

Read more
28 7,755  38
Nov 30, 2019

In late 2019 DJI made inroads into the FPV scene with their remarkable low-latency digital system. It gave us a 720p video feed with latency on-par with the status quo, analog video. Traditionally we've used analog video systems for low-latency video, but the video quality is far from ideal. It's a trade-off we've been willing to accept for the control. Now we've got the best of both worlds and what..

Read more