This is the prototype of the brand new AirBlade Intrepid V2 7 inch. It utilizes the same body as the 5 inch, but the arms are now single arms instead of dual arms design. Similar to the 5 inch version, the bottom plate has dual 30x30 stacks and 20x20 stacks, whichever you decide to use.

In this build, I use the BrainFPV Radix and Spedix GS40 4in1. I also heard good things about the ETHIX Konasty 2407 Moon Boot so I decided to put them on here. The motors are really smooth, the only complaint I have about this motor is that the wires are too short for 7 inch. I suspect they're short even for 5 inch. Hence you see that I had to use the TBS Racewire on the arm. Ideally I would want to not have to use any additional hardware here.

I intend to use up to 4000mah 4S on this build for more flight time. The top plate can comfortably take 2200mah 4S. So either I need to do double batts, or bottom mount a big 4000mah 4S.

In near future, I will be releasing 2x 3D pritned parts for this frame

1. Antenna/GPS/XT60 mount on the back
2. GoPro Hero7 mount on the front with less agressive angle for those who want to do more cinematic filming where the built in angle is a little more aggresive
3. TBD - GoPro session mount with similar funciontality as the GoPro Hero 7 mount.