First want to say thanks to OptimaZe for the frame! I'd been wanting to build a brushed "toothpick" for quite awhile now, but frames for such a thing just seem hard to find, especially since I do not own a 3d printer. But I was luckily able to get my hands on one so I was finally able to put one of these together. Really simple straight forward build, very little soldering especially since I went for an AIO board with an spi rx. If I were using a full size rx, I would've positioned the vtx antenna in a more ideal position, but this obviously isn't a build with long range in mind, that's why the antenna is placed where it's at. The only issue I came across with this frame is that the flight controller has to sit quite high which makes it so that both the standard, and extended whoop styled fc grommets will not work, unless you want to flip the fc. I ended up gluing the taller grommets to the frame with some Uhupor (amazing stuff for foam plane repairs), then placing my fc and canopy on top, then again using Uhupor to glue some small screws into the top side of the grommets. Everything seems to be holding fine, but I really won't know til I fly it and get a few crashes under its belt.