well maybe resin printed frames dont hold up so well... Back to the 2" tinyhawk race frame. this time the weight is 91g auw with the runcam thumb attached.

this is the fourth build in my search for a small and light carrier for the runcam thumb camera.
so far, the 1s 40mm whoop carrier gives the smoothest footage but with very limited power/agility.
https://rotorbuilds.com/build/29739

with the 2s 2.3" build gave better power and agility but introduced camera shudder at higher speeds.
https://rotorbuilds.com/build/29742

next build used 2" props on a 2.5" printed tinyhawk freestyle frame. this was the best compromise of flyability and decent/stable footage. unfortunately, my resin printed frame was slightly heavier and far too brittle for regular flying.
https://rotorbuilds.com/build/29805

the current build reverts to the 2" carbon frame from the tinyhawk II race edition(what i had) modified to hold m2 screws /standoffs and fitted with a semi rigid canopy printed with a sirayatech tenacious flexible resin blend.

first flight: