This is my first build from scratch, I'm still missing a Vtx, an Antenna and batteries. Any suggestions?
Frame |
Japalura 4
(13 builds)
Armattanquads.com
|
$77.00 |
Flight Controller |
KISS CompactCTRL CC All-in-One
(42 builds)
Flyduino.net
|
See Site |
Motors |
4 x Brotherhobby Tornado T1 1407 3600KV Brushless FPV Racing Motor
(193 builds)
Flyduino.net
|
See Site |
Propellers |
4 x Diatone Bull Nose Polycarbonate 3-Blade Propellers 4045 (CW/CCW) (Orange) (2 Pairs)
Hobbyking.com
|
$6.56 |
FPV Camera |
Runcam Swift Mini 130 Degree 2.5mm FPV Camera Build in OSD PAL/NTSC Orange/Black 22*22mm RC Drone
(59 builds)
Banggood.com
|
$34.99 |
Receiver |
Turnigy iA6C PPM/SBUS 8CH 2.4G AFHDS 2A Telemetry Receiver
Hobbyking.com
|
$9.89 |
Where did you get that battery pad? I didn't get one with my frame kit.
how much does that frame weigh? it might be pushing the motors a bit too much if you run 4s with those props
Have you flown with those props? I'm curious if the KISS CC can handle the amp draw.
for your batteries - Turnigy Graphenes are awesome.
AirbladeUAV has done it again and this time they've brought long range to the 5" class! Based on the popular Transformer Mini, the new Transformer 5" Ultralight adopts a lot of the same design philosophies with larger props and more payload capacity. It can fly upwards of 20 minutes on a 4 cell Li-Ion battery pack and in ideal conditions it's got a range of over 4 to 5 miles. In this guide I'll walk..
Read moreWith the release of the DJI FPV Drone cinematic FPV has become a lot more accessible, but you certainly don't want to crash a $750 drone! The QAV-CINE Freybott is a compact, lightweight cinematic FPV drone that can take a hit and keep going. It's a lot safer to fly indoors and around people. With a naked GoPro or the SMO 4k you can capture some great stabilized footage. In this guide I'll show you..
Read more
How do you like the Kiss all in one? Im putting one in my Japalura build
I have only flown a few packs so far because I've been busy with exams but it feels very crisp. The build process was relatively easy and it makes for a very nice and clean build. Good luck with your build
How was it soldering the motors? The tabs look really small!
Yeah they are small but I'm still a beginner at soldering and I managed to do it so it should not be a problem.